The necessity of daily operation and maintenance of large mesh belt dryer is self-evident.

- May 03, 2019 -

The < strong > mesh belt dryer is a batch and continuous drying equipment. The main heating methods are microwave heating, heat pump heating, electric heating, steam heating and hot air heating. The main principle is to lay the material evenly on the mesh belt. The mesh belt uses 12-60 mesh steel wire mesh belt. The drier is driven by the transmission device to move back and forth in the dryer. The hot air flows through the material and the steam is discharged from the dehumidification hole. The length of the box body is composed of standard sections. In order to save the space, the dryer can be made into multi-layer type. Three layers, five layers, 6-40m in length and 0.6-3.0m in effective width. Installation and maintenance of

mesh belt dryer : & ensp; maintenance of belt drying equipment is an extremely important and regular work, which should be closely coordinated with extreme operation and maintenance, and full-time personnel should be on duty for inspection.

1. The equipment should be installed on a horizontal concrete foundation and fixed with foot bolts. & ensp; & ensp;

< p > 2. When installing, attention should be paid to the vertical of the host body and the horizontal. & ensp;

< p > 3. After installation, check whether the bolts in all parts are loose and whether the main engine door is tightened. If so, tighten it. & ensp;

< p > 4. Configure power cord and control switch according to the power of the equipment. & ensp;

< p > 5. After the inspection, the production can be carried out without load test, and the test run is normal. & ensp; < p > < p > 6, bearing bears the whole load of the machine, so good lubrication has a great impact on the life of the bearing, which directly affects the service life and operation rate of the machine. Therefore, the lubricating oil injected must be clean and the sealing must be good. The main oil injection place of the machine must be (1) rotating bearing (2) rolling bearing (3) all gears (4) movable bearing, sliding. Motion plane. & ensp;

7. Frequent loosening of newly installed tyres must be checked. & ensp; & ensp;

8. Attention should be paid to the normal operation of all parts of the machine. & ensp;

9. Attention should be paid to checking the wear degree of wear-prone parts and replacing wear-prone parts at any time. & ensp;

10. Place the bottom plane of the movable device so as not to encounter dust and other objects. When crushing material, the movable bearing can not move on the chassis, resulting in serious accidents. & ensp; & ensp;

< p > 11, bearing oil temperature rise, should stop immediately to check the reasons to eliminate. & ensp; & ensp;

< p > 12. If there is an impact sound in the running of the rotating gear, stop immediately to check and eliminate it.

Continuous mesh belt drying equipment has many varieties and complete functions. Among them, the microwave hot air drying equipment series includes single-layer mesh belt type hot air drying equipment, multi-layer mesh belt type hot air drying equipment, single-layer mesh chain type hot air drying equipment, multi-layer mesh chain type hot air drying equipment, multi-layer flip plate type hot air drying equipment, and the belt drying equipment manufacturer delivered to production has a wide range of cases, covering food, medicine, chemical industry, agricultural and sideline products, Chinese medicine processing, building materials. Metallurgy and other industries of national economy. It is self-evident that

large mesh belt dryer is necessary for daily operation and maintenance. It provides various types of drying equipment selection schemes and quotations. This paper comes from the microwave hot air drying equipment () network.

上一篇:Microwave Food Extruding Equipment Satisfies the Benefits of Food Enterprises and Diners 下一篇:High-efficiency co-production of special net belt dryer for duck tongue to meet market demand

Related News

Related Products