Passed the ISO9001 quality system certification and the establishment of industrial drying industry alliance standards under the guidance of the Chinese Standardization Research Institute.
- May 03, 2019 -
The conveyor net chain should generally start under no-load condition. When several belt conveyors are installed sequentially, the starting device that can be blocked should be adopted to start and stop in a certain order through the centralized control room. In addition to
, in order to prevent unexpected accidents, each conveyor should also set a button to start or stop in situ, which can stop any one of them independently. In order to prevent the conveyor belt from being torn longitudinally for some reason, when the length of the conveyor exceeds 30 m, a stop button should be installed along the full length of the conveyor at a certain distance (e.g. 25-mdash; 30m).
Attention should be paid to the deviation of conveyor belt during operation, the operating temperature of driving part, the movement of idler during operation, the tightness of contact between cleaning device and guide plate and the surface of conveyor belt, and necessary adjustments should be made to ensure that all parts are normal before running the test machine with load.
Conveyor network chain If the screw tensioner is used, the tightness of the conveyor will be adjusted again when the machine is running under load. Install the driving device. When installing the driving device, attention must be paid to making the transmission shaft of the belt conveyor perpendicular to the center line of the belt conveyor, so that the center of the width of the driving drum coincides with the center line of the conveyor, and the axis of the reducer is parallel to the transmission axis.
At the same time, all axles and drums should be leveled. Horizontal error of axle is allowed in the range of 0.5-mdash and 1.5mm according to the width of conveyor. The conveyor net chain While installing the driving device, the tail wheel and other tensioning devices can be installed. The axis of the drum of the tensioning device should be perpendicular to the center line of the belt conveyor.